English
Français
EspañolFirst of all, the customer should send the product drawing to the director of the stamping die design department, and the design director should confirm whether the product can be made with the technology of the department.If you can, leave it to the designer to prepare the drawing.
Of each board mould needs to buy back, first rough machining way, the thickness of the template grinding to a certain size, usually both sides were leave allowance of article 50 (0.50 mm), best after rough machining, sent to heat treatment.
At the same time, design department staff held a seminar to develop the product step by step process drawing, discharge material belt drawing.It is impossible for a product to be produced only through one process, and it must be combined with other processes to produce a qualified product.
After the product process diagram is determined, the designer starts to design the mold.The whole mold design such as draw out the figure after all of the parts, mould will be ready to begin processing, first is template grinding to the correct size, and then discharge, threading hole, thread cutting, cutting into the hole again, blade, blanking and so on, then sent to the milling machine and CNC machining countersunk head, way and so on, finally by qa inspection, unqualified is rework, return the responsibility department qualified after can be sent to the warehouse inventory.
The last by a fitter, from warehouse group stand in front of the preparatory work, such as chamfer, place for burr, rust, confirm the size, check whether all processing in place, if lack of holes and hole and screw tooth missing, mold parts to can start assembling mold for a while, to install a bit, such as mold parts here later, mould almost packed, all parts than all here to save a lot of time.
Mould assembling finished, began to test, debug, mold, until the mold can produce size accuracy, the appearance quality of composite products, and then sent to the customer sign sample, the customer to confirm ok, a set of mould all the work in order to be officially completed, will wait for the machine production.After that is to repair molds, maintenance molds.The mold is fine. The locksmith is fine.
Contact:
Shine
Email: [email protected]
Mob(What‘s app): +86 15757668880
QQ: 740573849
Wechat: 15757668880
http://www.chinaplasmould.com
.png?imageView2/2/w/105/h/83/format/jp2/q/75)
